![]() I also changed the water pump with a slightly better and larger aquarium pump, here it is important to always have control over the flow, a sensor / auto switch is the safest. The air nozzle or compressed air is absolutely necessary, not only for cutting and engraving, but also for keeping the optical lens clean. If you are a little technically interested you will go through a nice development that ends with beautiful and useful items you have made and the quiet desire or dream of a bigger machine and of course this forum here.ĭon’t get frustrated, take it as a challenge. Much of this statement is due to the amazing development Lightburn has received, the super fast and noble service from Oz and Co. ![]() Going to fiddle with the driver some, see if I can figure it out.I’ve run T2Laser before Lightburn and still think it’s a very fine and universal program, but, Lightburn is definitely the best solution (for my needs). Similar results, think the only difference was I didn’t get the error about driver failing to restart. Everything was working last time I used lightburn a few days previously, and stopped working when I updated. Uninstalled and followed the procedure you listed above. Then have Windows reinstall the driver or get the latest driver from WCH: Try removing the driver entirely in the Driver tab removing all remnants of the driver. You have a bad driver or driver conflict on the WCH340.(mouse, keyboard, monitor, headphones, etc…) Seems a stretch as everything else is working. If the laser is working when you don’t receive the USB error then this seems less likely. The USB port on the controller side is damaged.When this happens does LightBurn connect and work correctly?ĭid you attempt the order of operations I listed above?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |